Service manual

05-45
✰ Assemble circlip on the selector
shaft.
✰ Assemble RH selector fork as shown
in Fig.
✰ Assemble LH selector fork on the
selector shaft and then insert centre
fork so that the cut shoulders of both
the forks are matched.
✰ Assemble selector fork sub
assembly over main and Layshaft sub
assy. as shown in Fig.
✰ Always assemble the cam plate on
selector fork sub assembly in 3rd
gear position & ensure the 4 rollers
are in good condition and located
properly.
✰ Locate special thrust washer
(Layshaft) on Crank case RH and
stick using grease.
NOTE :NOTE :
NOTE :NOTE :
NOTE : Ensure special thrust washer
profile is facing towards sleeve gear.
Engine Dismantling, Inspection & Assembly