Service manual

05-47
✰ Check Crank shaft big end bearing
axial play is within service limit.
✰ Check Crank shaft run out is within
service limit.
✰ Assemble the crank shaft into the
crankcase RH.
NOTE :
Ensure the bearing inner races
(small one on timing shaft & big one
on drive shaft) are fitted on the crank
shaft before assembling in the
crankcase RH.
✰ Assemble “O” ring, cap pivot, copper
washer and tighten bolt (Torque 1
KG-M).
✰ Assemble special thrust washer (lay
shaft) on Crank case LH.
✰ Assemble the 2 dowel pins on the
crankcase and apply LOCKTITE
5699 RTV silicon liquid gasket on
the RH Crank case seating surface.
NOTE :
Ensure
special thrust washer profile
facing towards Crank shaft bearing
side on LH Crank case.
Engine Dismantling, Inspection & Assembly