Service manual

05-60
✰ Assemble Breather bolt and washer
(Torque 2.0 KG-M).
✰ Assemble Ignition Timing inspection
bolt with copper washer (if not
assembled earlier) Torque 1.5 KG-
M.
✰ Assemble jet Crankshaft, oil seal
Crank feed and circlip on cover RH
inside.
✰ Assemble Stator on cover RH and
tighten with 3 mounting screws
(Torque 1 KG-M).
✰ Assemble Pulser coil on cover RH
and tighten with 2 screws (Torque 1
KG-M).
NOTE :
Apply LOCKTITE 595 silicon ad-
hesive sealant to magneto wire cable
grommet to avoid oil seepage.
✰ Assemble 2 dowels and RH Crank
case cover gasket.
NOTE : Replace the oil seal every 20,000
kms interval.
Engine Dismantling, Inspection & Assembly