Service manual

02-11
1 ST-25118 - 4 Cylinder head nut tightening tool To remove and tightening of
cylinder head nut.
2 ST-25123 - 1 Valve spring compressor To compress the valve spring for
removal and fitting of valve.
3 ST-25612-4 Rotor tightening & loosening tool To hold magneto rotor while loosening
magneto nut.
4 ST-25128 - 2 Puller for magneto rotor Removal of magneto rotor assy.
5 ST-25592-4 Connecting rod locking tool To hold connecting rod in its top position.
6 ST-25151-4 Puller for chain case outer To remove Crankcase LH cover.
7 ST-25591-4 Sprocket & Clutch tightening tool To hold the clutch housing and sprag
sprocket while dismantling & assembly.
8 ST-25594-4 Clutch plate tightening tool To compress clutch springs while
dismantling & reassembling of clutch plates.
9 ST-25153 - 4 Extractor for gear box rocker Removal of rocker shaft spring top
pivot pin pivot pin and camplate pivot pin.
10 ST-25835-2 Front drive sprocket removing To remove FD sprocket on the sleeve
tool gear.
11 ST-25834-2 Front fork dismantling tool To hold pipe seat of front fork while
dismantling main tube with bottom case
(fork end assy.)
12 ST-25114-4 Extractor for fork oil seal To remove oil seal from front fork end
assy. (bottom case)
13 ST-25113 - 4 Mandrel for oil seal Fitment of oil seal in front fork end assy.
14 ST-25112-4 Expander for front fork Oil seal Expanding the oil seal lip while inserting
main tube into bottom case of front fork.
15 ST-25110-3 Gauge plate for tightening Alignment of swing arm while
chain stay mounting / tightening into chassis.
16 ST-25244 - 4 Special spanner adjuster To adjust gas filled shock absorber
spring load.
SL.
PART NO. DESCRIPTION APPLICATION
NO.
List of Special Tools & Its Application