Service manual

06-10
The Roll over sensor is also known as a bank angle sensor. If the motorcycle is banking
below 60° from the road surface OR in the event of an imminent falling over in a mishap,
this sensor signals the ECU which in turn will cut off the fuel supply to the injector and
the ignition, thus stalling the engine to prevent further damage that may be caused if the
engine is still running with the throttle stuck wide open and the gears are engaged.
The Rollover Sensor is located under the seat on the vehicle-mounting strip of the frame.
ROLL OVER SENSOR
Assembled under the seat
Specification:
Operating Voltage : 12V.
Operating Angle : 60° + 10°.
Operating Temperature : –20°C to
+85°C.
Function of Components in EMS