Service manual

07-4
Dismantling Proceedure - Carburetor
3 Remove drain hose and air vent hose.
NOTE :
Inspect both hose pipes for clog. Clean
thoroughly before fixing.
3 By using the right size spanner to
remove the choke plunger sub assy.
along with the spring.
CAUTION :
In case of lever type choke plunger assy.
it comes out as a single unit.
NOTE :
Inspect choke piston and needle. Clean
by solvent & wipe dust / carbon particals
by banian cloth.
3 Unscrew the top cover fixing screws
and remove the diaphragm top cover,
piston valve spring from the
carburetor as shown in Fig.
3 Gently remove thorottle piston valve
assembly as shown in Fig.
Note : Care to be taken while removing
diaphragm top cover due to spring force.
DRAIN HOSE
3 Unscrew the float body fixing screws
and remove the float chamber body
assy. from the mixing body along
with “O” ring.
3 Unscrew the float toggle pin
mounting screw and then remove the
float body unit along with needle
valve assy.