Service manual

07-7
3 Assemble float chamber body along
with “O” ring as shown in Fig.
NOTE : Ensure that float body swinging
freely on float toggle pin. Recheck again
float height after the adjustment.
3 Inspect rubber diaphragm and
retainer ring. In case of dust or
carbon particals wipe with banian
cloth carefully before assembling
into mixing body.
NOTE : NOTE :
NOTE : NOTE :
NOTE : Lubricate a thin film of engine
oil on throttle pistion valve before fixing
into mixing body.
3 Assemble throttle piston sub
assembly by locating rubber tip tab
being seated on the mixing body.
Fix pistion valve spring and top
cover as shown in Fig.
3 Assemble air vent hose and then
drain hose.
3 Assemble choke plunger sub
assembly into mixing body and
tighten the nut.
NOTE : Do not clean diaphragm by brake
fluid or compressed air.
INSTALLATION OF CARBURETOR
3 Follow the reverse order of removal
process.
NOTE : NOTE :
NOTE : NOTE :
NOTE : After installation check for any
fuel leakage from the carburetor or fuel
hose.
Assembling Proceedure - Carburetor