Service manual

08-18
WHEEL DISC INSPECTION
Check the wheel disc periodically for any oil or grease stains, slush, grit, scoring marks
etc. Keep the disc clean and dry at all times for the brakes to work at peak efficiency. If the
Disc is scored heavily, replace the disc. IF the scoring is very mild, remove the same using
a mild abrasive paper.
REAR WHEEL REMOVAL
Rear wheel can be dismantled without
removing the rear chain and rear wheel
sprocket.
✰ Place the vehicle on its center stand
✰ Ensure the rear wheel is lifted off
the ground by placing suitable
wedges under the centre stand legs
✰ Remove the split pin and the castle
nut from the rear hub spindle
✰ Pull out the spindle with the chain
adjuster and remove the spacer from
the LH side.
✰ Tilt the vehicle to the right and free
it form the sprocket lugs and slid it
outwards
✰ Check the Disc thickness and the ‘Run-Out’ of Disc.11
Sl. No. Parameter Service Limit Inspection method
1 Disc Thickness As described on the disc
2 Disc runout 0.3mm
Chassis, Wheels & Brakes