Service manual

09-7
REMOVAL AND ASSEMBLY OF
REAR SHOCK ABSORBER
✰ Remove the top and bottom mounting
nuts and washers.
✰ Pull out the shock absorber from
bottom and slide out from frame.
✰ Assemble in the reverse of removal.
RECHARGING OF SHOCK
ABSORBERS
✰ Remove the small screw with “O”
Ring.
✰ Inject the special purpose needle into
the hole provided in the screw
(Puncturing the rubber) and start
pumping the air into the chamber
till the pressure reached to 100 PSI
(7 BAR). Tolerance for filling
pressure can be 6.7 BAR to 7 BAR.
✰ Fit the small screw with “O” Ring.
NOTE:
The shock absorber needs recharging
when the system pressure is less than 5
BAR.
SWING ARM
REMOVAL
✰ Remove the chain link and take out
the chain.
✰ Disconnect the brake rod nut.
✰ Remove the rear wheel sprocket
assembly (1).
✰ Remove the shock absorbers (2).
11
11
1
22
22
2
Suspension & Steering