Service manual

09-9
✰ Apply grease inside the bush and
then insert spacer as shown in Fig.
✰ Position special tool ST 25110-3 on
shock absorber mounting pins.
✰ Position it on frame and insert the
swing arm hex bolt after applying
grease.
✰ Place a washer and tighten nut.
✰ After tightening the swing arm hex
nyloc nut. Remove special Tool ST
25110-3.
✰ Fix both side caps swing pivot
carefully.
✰ Assemble both side shock absorbers,
washers and dome nuts as shown in
Fig.
✰ Assemble the chain guard.
✰ Assemble the rear wheel and adjust
drive chain free play.
Suspension & Steering