Service manual

03-29
Periodical Maintenance
✰ Over size Cam Spindle (For Spares)
570040 : 0.1 mm Over size Spindle
570041 : 0.2 mm Over Size Spindle
CAUTION :
- During first service, the backlash
between the cam gears must be
checked. If not with in the desirable
limit and if a slight cam noise is
observed, then further adjustment
of the eccentric sleeve has to be
carried out as mentioned above.
- After adjustment to the required
backlash, both the Inlet & Exhaust
lock nut in the spindle must be
tightened to the specified torque.
BATTERY
ELECTROLYTE LEVEL CHECKING :
✰ Electrolyte level can be seen
through the casing.
✰ Electrolyte to be filled upto “MAX”
Mark.
NOTE :
When electrolyte level drops to “MIN”
Level, then top up distilled water upto
“MAX” Level.
✰ Specific Gravity -
Fully charged 1.24 to 1.26.
Needs to be recharged 1.15 or less
than that
TERMINAL CLEANING :
✰ Clean terminal with warm water and
apply petroleum jelly.
✰ In case of sulphation clean by zero
base emary paper.
✰ If required, top up with distilled
water.
SPECIFIC GRAVITY CHECKING :
✰ Check specific gravity (SG) with a
hydrometer.