Service manual

05-12
CAUTION :
Tap only at the places shown to avoid dam-
age to the RH cover
✰ Remove Stator assembly by
removing 3 mounting screws.
✰ Remove Pulser coil by removing 2
screws
✰ Remove RH cover gasket & 2 dowels.
NOTE :
Remove the stator coupler from the
wiring harness before removing RH
Cover.
Place a plastic tray below the RH cover
for collecting the oil that will drip while
removing the cover.
✰ Remove the 11 bolts securing cover
RH. Gently tap & pull out the cover
evenly
✰ It may be necessary to tap the cover
slightly to remove since the
magnetic forces in the rotor can be
acting on the stator and making it
difficult to remove
Engine Dismantling, Inspection & Assembly