Service manual

05-14
✰ Remove the 2 oil seals from the Kick
Shaft hole
COMPONENTS FOR DISMANTL-
ING FROM CRANKCASE RH
REMOVAL OF ROTOR ASSEMBLY
✰ Loosen and remove magneto lock nut
and plain washer.
✰ Ensure the connecting rod is locked
properly with the special tool resting
firmly and evenly on the crankcase
top position.
✰ Use Special tool No. ST - 25128-2
Magneto removing tool to remove
rotor assembly.
✰ Remove the 3 allen screws & 2
dowels from Cam steady plate.
✰ Remove Cam steady plate and the
shims.
NOTE :
Check the number of shims on inlet and
exhaust cams. It is important to reduce
noise and axial play between the cam gear
face and the cam steady plate.
OUTSIDE OIL SEAL
INSIDE OIL
SEAL
Engine Dismantling, Inspection & Assembly