Use and Care Manual
Table Of Contents
Page 8 of
13
FOR YOUR SAFETY, READ BEFORE LIGHTING
• Before performing a leak test, make sure that no sparks can occur and you
are in a spacious outdoor area.
• Connect the propane gas tank to the regulator and turn the valve on the
unit to the “off” position.
• Brush a soap and water mixture on all connections.
• Make sure the igniter battery has been installed properly. The igniter will
not operate otherwise.
• Before operating, smell around the appliance and next to the ground for
gas odors. If you smell gas or a leak is discovered turn the gas valve off,
disconnect propane gas tank and do not use the appliance until the leak is
repaired.
• After turning the gas supply, if bubbles occur on any connection there may
be a leak.
• Do not use the appliance if any part has been submerged under water.
Immediately call a qualified service technician to inspect the unit and to
replace the part.
• Do not use the heating unit without inspecting the gas hose (if applicable).
• If there are signs of wear or abrasion, please immediately replace the
hose.
• Pumice stones/lava rocks/Lava Glass could pop up and strike somebody’s
face during the process of lighting this unit; stand away from the unit for
the first 20 minutes after igniting.
Operation