Instructions / Assembly

GB
4
-The barbecue grill is safe and easy to use.
-Please ensure you only use your barbecue at the correct pressure which the appliance is designed for.
-With a grease tray and a grease cup under the case.
-Adequate ventilation is vital for combustion and effciency performance of the barbecue. This will ensure the safety
of the user and other people in the vicinity of the area where the appliance is being used. Never use the appliance
in any enclosed covered area.
-When the wind speed is above 2m/s, don’t use gas grill facing to the wind.
-The appliance is designed for use outdoors only.
-Warning! Accessible parts may be very hot. Keep young children away.
-Read the instructions before using the appliance.
-Do not move the appliance while in use.
-Turn off the appliance at the cylinder valve or regulator after use.
-Any modifcation to the appliance may be dangerous and may cause injury or property damage.
-Any unauthorised modifcation of the appliance will invalidate the guarantee on this appliance.
-Never mount the cylinder under the barbecue on the base shelf as this could result in serious injury to the user,
other people and/or property.
-The appliance must not have any overhead obstruction. E.g. trees, shrubs, lean to roofs. The appliance must be
install with a clearance of 1m around the appliance.
-The appliance must not be used near fammable materials. (Petroleum based products, thinners or any other solid
object that carries a fammable warning label.)
-Close the valve of the gas cylinder or the regulator after use.
-The use of this appliance in enclosed areas can be dangerous and is PROHIBITED.
INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your barbecue and causing injury to yourself and to
property.
1. Assemble the barbecue following the assembly instructions carefully.
2. Connect the gas hose to the barbecue. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions supplied with the regulator.
4. Turn all of the control knobs to the ‘OFF’ position before turning on the gas supply to the appliance.
5. Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING YOUR BARBECUE
Lighting Instructions
1. Turn the control knob clockwise to “OFF” position.
2. Open the hood before use.
3. Connect the regulator to the gas bottle. Turn the gas supply “ON” at the regulator. Check with the use of soapy
water for any gas leakage between the bottle and the regulator.
4. Push down the control knob and keep pressing while turning it anti-clockwise to the “Full rate” position.
5. If the burner has not lit in 3-5 seconds, turn knob off, wait 5 minutes and repeat step 4.
6. Repeat step 4 to 5 for other burner.
7. Adjust the heat by turning the knob to the High/Low position.
8. To turn the barbecue OFF’: turn the cylinder valve or regulator switch to the ‘OFF’ position and then turn all
control knobs on the appliance clockwise to the ‘OFF’ position.
If the burner fails to ignite, turn all control knobs off (clockwise) and also turn the cylinder valve off.
Wait ve minutes before attempting to relight with ignition sequence.
GENERAL SAFETY INSTRUCTIONS
Push ignitor button rapidly.
WARNING
1. Turn the control knob clockwise to “OFF” position.
“OFF”
“OFF”
“OFF”
“OFF”