User's Manual

~ 3 ~
INSTALLATION THE MONITOR
Safety Checks
Make sure the monitor and system unit power switches are off,
when you start connecting cables. This monitor is set for 100-240
Vac 60/50 Hz (full range). Confirm the line voltage for your
monitor by checking the voltage label on the rear panel of the
monitor.
Figure 3 Connecting the Video Cable and Power Cord
Connecting the Video Cable
The monitor comes with a built-in video cable. To connect the
video cable, follow the steps below:
1. Plug the signal cable’ s 15-pin connector into the computer’ s
video port.
2. Tighten the two screws on the cable connector. As Figure 3.
Connecting the Power Cord
CAUTION: If the AC inlet in your location does not provide for
this type of grounded plug, make sure to install the proper adapter
for a safety grounding.
This monitor comes with a power cord. See Figure 3. Plug power
cord into a computer’ s inlet. The three-wire power cord must be
provided a safety precaution to ensure proper electrical grounding.