FAQ

FAQs
What is the best caulking to use with your
Brick Mould, Thermo Stop and Jamb?
We recommend using Liquid Nails Super Caulk Window
& Door LC130 for indoor/outdoor use.
How do you clean the product?
We recommend cleaning our exterior mouldings with the
following cleaners: Windex®, Glass Plus®, 409® Glass
& Surface Cleaner, Spic and Span®, Cinch®, Fantastik®
All-Purpose, Regency® Glass & Surface, Clorox® Clean-Up®
or Fantastik® Orange Action®. The cleaning solution should
be applied and immediately wiped dry. The cleaning solution
should not be left to stand on the components for an extended
period of time.
What colors are your exterior mouldings offered in?
Our exterior mouldings are available in Bright White.
Our Garage Door Stop is available in White, Sandstone,
Brown, and Almond.
What surfaces can your moulding be attached to:
plaster, stucco, vinyl, brick, concrete, wood?
The moulding can be attached to any of the above surfaces.
How do you cut the moulding?
Royal Mouldings can be cut using standard woodworking
equipment. If using a power miter saw, we recommend using
a carbide-toothed blade with 80 teeth or more.
Do you have to pre-drill before nailing?
If nailing product at 40°F or below, pre-drilling is required.
What kind of nails do you use?
Royal Mouldings can be installed with nails or construction
adhesive. If nailing, use galvanized finishing nails for exterior
applications. Place nails 12" on center approximately 3/4"
from each edge.
Can you use a nail gun on your products?
Royal Mouldings can be installed using pneumatic nail guns.
Can I use screws in your moulding?
Yes, we recommend a non-corrosive metal such as galvanized,
stainless or coated screw for exterior applications.
Can you paint the flex on Garage Door Stop?
No, we do not recommend painting the flex.
1. When installing Garage Door Stop alone, open the garage door and
remove old door stop with standard claw hammer.
2. Close garage door. Begin Garage Door Stop installation by measuring
and marking 1/2" from outside of garage door several places around
the jamb. Connect the marks with a straight edge, then open door
again.
3. Measure top opening from side to side and cut Garage Door Stop
ends square with fine tooth power or hand saw.
4. Place grooved side against jamb and inner edge, (where hard vinyl
joins weatherstrip) along marked lines. Nail in place with 6d
galvanized finishing nails in the pre-punched nail guides or 8" on
center.
5. Measure and cut each piece to fit, from top piece to floor. With
grooved side against jamb, position nail as directed.
6. For a good drainage and overlap, trim side stop pieces at a 45° angle
with scissors where the soft vinyl weather stripping meets the top.
Garage Door Stop Installation
Garage Door Systems