Owner's Manual HIGH SPEED BILL COUNTER WITH COUNTERFEIT DETECTION RBC-5000 Royal Sovereign International, Inc. Please read and retain these instructions. To register your product, please go to www.royalsovereign.
Thank you for purchasing the Royal Sovereign High Speed Bill Counter with Counterfeit Detection, RBC-5000. This manual will provide you with safety information, instructions for optimal use, and proper care and maintenance for your product. Please read this manual carefully before operating. CONTENTS SAFETY INSTRUCTIONS ............................................................................... BOX CONTENTS & PRODUCT VIEW ..................................................................
SAFETY INSTRUCTIONS When using this machine follow these basic safety precautions to reduce risk of fire, electric shock, or injury. WARNING 1. Only use the power cord that comes with the machine. Using a different power cord may result in electric shock, fire, or cause serious damage to the machine. Plug the power cord into a properly grounded wall outlet. 2. 3. 4. Do not use the machine if the power cord is damaged. This may result in electric shock, fire, or other hazards.
BOX CONTENTS Bill Counter Power Cord PRODUCT VIEW Hopper Control Panel Bill Receiving Vanes 3
QUICK START GUIDE 1. Plug the power cable into the back of the unit and into the wall power outlet. 2. On the back of the machine, flip the power switch to power on. 3. The machine will go through an automatic self-diagnostics test to ensure accurate bill counting. The counting wheels in the bill counter will spin several times to ensure it is ready for use. When the machine has completed its test run and "0" displays on the machine, it is now ready for counting. 4.
CONTROL PANEL UV Counterfeit Detection Counterfeit bills often use white or bleached paper, which will glow under ultraviolet light. To use ultraviolet counterfeit detection, press the "CF" button and then the "UV" button (#8 on the numeric keypad). Press the "CF" button and then the "UV" button to disengage the UV function.
PRODUCT OPERATION 1. 2. Attach power cable to back of machine, plug into a three prong outlet, and turn power switch on. The unit will conduct an automatic self-diagnostic test to ensure accurate counts. After five seconds, the screen will display a "0" on the left and on the right of the display with the word "AUTO" above the zeros. If there is a problem, the preset display will show an error code. (See ERROR CODE DISPLAYS -LOCATED ON PAGE 10.
PRODUCT OPERATION (CONTINUED) - - 3. 7 Counterfeit Detection Methods Ultraviolet and Magnetic Counterfeit Detection Methods are automatically on when the unit is powered up. To manually turn off any or all methods see (CONTROL PANEL - LOCATED ON PAGE 5.) AUTO or MANUAL Start The machine is preset to automatically start counting bills once placed into the hopper. To change to the manual start mode, press the "CF" button and then the "AUTO" button (#2 on the numeric keypad).
MAINTENANCE OF THE MACHINE WARNING: Before doing any dusting, turn the power switch off and disconnect the power cord from the machine. It is very important to clean all the sensors in the machine with a soft brush to avoid any paper particles or dust from sticking to the light transmitter or the light-receiver sensors. It is important to clean the inside of the machine occasionally. Unplug the machine and lift the top cover to gain access to the interior.
TROUBLESHOOTING Note: when counting and detecting is not accurate, please check the machine as follows: Problem Reason Solution Bills get damaged Hopper Tension is too tight To loosen the tension, please turn the bill thickness adjuster (located on the top of the machine) one notch to the right (+). Repeat bill counting and adjust if problem continues.
ERROR CODE DISPLAY AND SOLUTIONS The display may show some error code in counting, which means there are some problems with the machine. Refer to the chart below to solve the error.
ONE YEAR LIMITED WARRANTY Royal Sovereign International, Inc. warranties this product to be free from defects in material and workmanship for a period of one (1) year. This warranty is extended to the original purchaser only. This warranty only covers products that are properly installed, properly maintained, and properly operated in accordance with the instructions provided.
