Use and Care Guide

CONTROL PANEL

UV Counterfeit Detection

Counterfeit bills often use white or bleached paper, which will glow under ultraviolet light. To use ultraviolet

counterfeit detection, press the "CF" button and then the "UV" button (#8 on the numeric keypad). Press the "CF"

button and then the "UV" button to disengage the UV function.

Magnetic Counterfeit Detection

If the magnetic detector does not find the presence of magnetic components that are standard in authentic bills, the

machine will stop counting to allow removal of the counterfeit bill. To use magnetic counterfeit detection, press the

"CF" button and then the "MG" button (#9 on the numeric keypad). Press the "CF" button and then the "MG" button to

disengage the MG function.

Infrared Counterfeit Detection

Most bills often have infrared markings. Infrared light is used to validate these markings. To use infrared counterfeit

detection press the "CF button" and then the "IR" button (#7 on the numeric keypad). Press the "CF" button and then

the "IR" button to disengage the IR function.

Dimensional Detection

The dimension detector measures the width of the center of each bill by using infrared light. If the detector finds an

odd-sized bill, the machine will stop counting to allow removal of the bill and display the error code on the preset

display. To use dimensional counterfeit detection, press the "DD" button. To adjust the DD level press the “DD” button

for 3 seconds, the display will show the current size (dd- -5). Press the numeric key 1 to 9 to adjust the level, 1 for

lowest, 9 for highest. After choosing the level number press the "RESTART" button to confirm. To disengage this

function press the "DD" button again.