User Manual

Auto and Manual Start Modes

The machine is preset to automatically start counting bills once placed into the hopper. To change to the

manual start mode, press "AUTO", insert the bills into the hopper, and press "START/RESET". Press "AUTO"

again to return to auto mode.

Dimensional Detection

To manually turn the DD function on/off, press the "DD" button. The DD indicator light will light up showing

that the function has been turned on. If the machine detects a counterfeit note, it will stop counting. The

preset display will show DD. Remove the suspicious note and press "START" to continue counting.

SET Key Function

Use the "SET" button to adjust the sensitivity of the Dimensional Detection and Double Note Detection.

Press the “SET” key once, the preset window will display DD, and the counting window will display 1~5.

These numbers are for DD sensitivity, 1 is for the lowest, and 5 is for the highest. Press the number key to

set it directly. Press the “SET” key twice, the preset window will display Double, and the counting window

will display 1~5. These numbers are for Double sensitivity, 1 is for the lowest, and 5 is for the highest. Press

the number key to set it directly.

Batch Counting Mode

The machine is preset to common counting mode. To count bills in batches, press "BATCH". To change

batch amount, use the keypad to enter a batch number between 1 and 999. Press "BATCH" or "CLEAR" key

to clear.

Add Mode

Use this mode to add the quantity of bills counted to get an accumulative total. To set the machine to add

mode, press the "ADD" button. The add indicator will light, showing that this mode is turned on. Place bills

into the hopper and the machine will automatically begin to count them. When you remove the counted bills

from the stacker and place new bills into the hopper it will continue counting where it left off on the previous

set of bills. To stop using the add mode press the "ADD" button again and the indicator light will shut off.

CONTROL PANEL FEATURES