User Manual

- The unit will conduct an automatic self-diagnostic test to ensure accurate counts.
- After five seconds of the counting wheels
spinning, the screen will display a "0".
- If there is a problem, the preset display will show an error code. (See ERROR CODE
DISPLAYS -LOCATED ON PAGE 8.)
 Select bill counting settings.
PRODUCT OPERATION
 Attach power cable to the back of machine, plug into a three prong outlet, and turn the power
switch on.
- Before counting, select counting settings that are related to your counting needs, such as:
Add mode or Batch mode.
3
Inser
t the bills into the hopper to begin counting.
MAINTENANCE OF THE MACHINE
W
ARNING: Before doing any dusting, turn the power switch off and disconnect the power cord from the machine. It is
very important to clean all the sensors in the machine with a soft brush to avoid any paper particles or dust from
sticking to the light transmitter or the light-receiver sensors. It is important to clean the inside of the machine
occasionally. Unplug the machine and lift the top cover to gain access to the interior.
If necessary, the glass surfaces of the detectors may also be wiped with a soft cloth damped with alcohol.
To get the best results out of your bill counter, Royal Sovereign recommends using Royal Sovereign Cleaning
Cards (RBC-CLN) to remove dirt, dusts, oils, and other contaminates from your bill counter. With the machine
on, simply run the cleaning card through the machine like a bill. This cleaning card will run through and clean the
sensors of dirt and other contaminates. Cleaning cards are recommended to be used after every 100 cycles.
CAUTION: DO NOT CHANGE THE POSITION OF THE DETECTORS AND/OR OPTICAL SENSORS
7