Owner’s Manual Split type wall mounted air - conditioner ^ Please read this owners manual carefully and thoroughly before operating the unit! Take care of this manual for future reference.
CONTENTS Operation and maintenance Safety Precautions 1 Notices for use 6 Names of each part 8 Clean and care 9 Troubleshooting 10 Installation service Notices for installation Install indoor unit 15 Install outdoor unit 18 Check after installation and test operation 21 Note: All the pictures in this manual are just schematic diagrams, the actual is the standard.
Safety Precautions Incorrect installation or operation by not following these instructions may cause harm or damage to people, properties, etc . The seriousness is classified by the following indications : WARNING This symbol indicates the possibility of death or serious injury. CAUTION This symbol indicates the possibility of injury or damage to properties.
Safety precautions The air conditioner must be grounded. Incomplete ground ing may result in electric shocks. ¬ Always switch off the device and cut the power supply when the unit is not in use for long time so as to ensure safety. NO ! Do not connect the earth wire to the gas pipeline , water pipeline , lightning rod , or telephone earth wire. If the power supply cable is damaged , it must be replaced by the manufacture or its service agent or a similar qualified person.
Safety Precautions Don't install air conditioner in a place where there is flammable gas or liquid. The distance between them 1 should above 3.3ft. Don't use liquid or corrosive cleaning agent wipe the air conditioner and sprinkle water or other liquid either. Don't attempt to repair the air conditioner by yourself. NO! ft 3 3. NO ! It may cause fire even explosion. Don't use air conditioner in lightning strom weather. Doing this may cause electric shock or damage to the unit .
Safety Precautions This product contains fluorinated greenhouse gases. Refrigerant leakage contributes to climate change. Refrigerant with lower global warming potential (GWP) would contribute less to global warming than a refrigerant with higher GWP, if leaked to the atmosphere. This appliance contains a refrigerant fluid with a GWP equal to [2088].
Safety Precautions CAUTION Don’t open the windows and doors for long time when the air conditioner is running. Don’t stand on the top of the outdoor unit or place heavy things on it. m NOT Otherwise, the cooling or heating capacity will be weakened. This cloud cause personal injuries or damage the unit . Don't apply the cold air to the body for a long time. Set the suitable temperature.
Notices for use The conditions of unit can’ t normally run Within the temperature range provided in following table, the air conditioner may stop running and other anomalies may arise . Cooling Outdoor Indoor Heating Outdoor Indoor "C ( Apply 109.4°F (Apply to Tto 1 ) T1) >43 °C ( Apply 125.6°F (Apply 3 ) T3) to Tto > 52 64.4°F <180 75.2°F > 240 70 < -19.4°F 80.
Notices for use Emergency operation If the remote controller is lost or broken , use force switch button to operate the air conditioner. If this button is pushed with the unit OFF, the air conditioner will operate in Auto mode. If this button is pushed with the unit ON , the air conditioner will stop running. Force switch Airflow direction adjustment 1. Use up-down swing and left-right swing buttons on the remote controller to adjust the airflow direction.
Names of each part Indoor unit Air inlet Force switch Air inlet grille Panel Air filter Pipe protection ring Air louver Air vent Air outlet Remote controller Outdoor unit Power cable — Air outlet grille Connecting pipe Drain hose Air outlet Note: All the pictures in this manual are just schematic diagrams, the actual is the standard. Plug , WIFI function, Negative-ion function, and Vertical and horizontal swing function both are optional,the actual unit shall prevail.
Clean and care Warning Before the cleaning of the air conditioner, it must be shut down and the •electricity must be cut off for more than 5 minutes, otherwise there might be the risk of electric shocks. Do not wet the air conditioner, which can cause an electric shock. Make sure not to rinse the air conditioner with water under any circumstances .
Clean and care Clean the air filter Mount the Filter 1 . Reinstall the dried filter in reverse order of removal, then cover and lock the panel. Check before use 1. Check whether all the air inlets and outlets of the units are unblocked. 2 . Check whether there is blocking in the water outlet of the drain pipe, and immediately clean it up if any. 3 . Check the ground wire is reliably grounded . 4 . Check whether the remote control batteries are installed, and whether the power is sufficient. 5 .
Troubleshooting Phenomenon Air conditioner can not operate at all. Troubleshooting the power been shut down? •Is the wiring loose? •IsHasvoltage too high or too low ? (measured by professionals) • Does it reach the set time for start up ? •Does the circuit protection device trip? Is the remote controller out of effective distance to the indoor unit? Are there any obstructions between the controller and the Is the battery exhausted? signal receptor? ^ Remote controller is not available .
Notices for installation Important Notices Before installing, please contact with local authorized maintenance center, if unit is not installed by the authorized maintenance center, the malfunction may not solved,due to discommodious contact. The air conditioner must be installed by professionals according to the national wiring rules and this manual. To move and install air conditioner to another place, please contact our local special service center.
Notices for installation Electrical Safety Requirements sure to use the rated voltage and air conditioners dedicated •Be circuit for the power supply, and the power cord diameter must meet the national requirements. the maximum current of air conditioner is > 16A, it must use •When the air switch or leakage protection switch equipped with protection devices. The normal operating range is 90%-110% of the local rated voltage • The minimum clearance between the air conditioner and the •combustibles is 1.5 4.
Notices for installation Requirements for operations at raised height 2m or higher above the base When carrying out installation at 6.6ft level, safety belts must be worn and ropes of sufficient strength be securely fasten to the outdoor unit, to prevent falling that could cause personal injury or death as well as property loss. • Grounding Requirements air conditioner is the type I electrical appliance and must •The ensure a reliable grounding.
Install indoor unit Dimension drawing of indoor unit installation Space to the ceiling , 15.9in cm above Space to the wall Space to the wall cmabove 7.9in < cm above 78.7in ^^ 7.9in cm above Space to the floor Mounting plate 1. The wall for installation of the indoor unit shall be hard and firm, so as to prevent vibration. 2 . Use the "+" type screw fasten the peg board, horizontally mount the peg board on the wall , and ensure the lateral horizontal and longitudinal vertical. 3 .
Install indoor unit Route of Pipeline z 1. Depending on the position of the unit, the piping may be routed sideway from the left or the right ( Fig 1 ), or vertically from the back( Fig 2 )(depending on the pipe length of the indoor unit). In the case of sideway routing, cut off the outlet cutting stock of the opposite side. Connecting Pipe Drain Hose and Cables Fig 1 Connecting Pipe Drain Hose and Cables Fig 2 Outlet material preparation _ Drain pipe connection ~ 1.
Install Indoor Unit Fixing the Indoor Unit - 1. Hang the indoor unit on the peg board , and move the unit from left to right to ensure that the hook is properly positioned in the peg board . 2. Push toward the lower left side and the upper right side of the unit toward the peg board, until the hook is embedded in the slot and makes a "click" sound.
Install outdoor unit Space to the obstruction 7.9in Above Dimension drawing of outdoor unit installation e - “ Air in side ov n 9i 3. Ab Space to the obstruction 11.8in Above 11.8in Above Space to the obstruction e ov in Ab 9 8. 7 Air out side Installation outdoor unit bolt inch Left installation feet 25.9(27.7)*16.4*10.9 665( 710 ) 42 280 ( )x 23.4(25.2)*18.9*10.1 25.7(27.7)*19.5*9.4 ( ) 27.3*29.1*19.5*9.4 ( 255 27.3(29.1)*19.5*9.9 ( 285 28.5(30.4)*21.3*11.1 ( ) 545 285 29.6(31.
Install outdoor unit Wiring Connection 1.Loosen the screws and remove E-parts cover from the unit. 2.Connect the cables respectively to the corresponding terminals of the terminal board of the outdoor unit (see the wiring diagram) , and if there are signals connected to the plug, just conduct butt joint. 3.Ground wire: Remove the grounding screw out of the electric bracket , cover the grounding wire end onto the grounding screw and screw it into the grounding hole. 4.
Install outdoor unit Expelling the air Outdoor unit refrigerant discharging method After the pipe side connection is complete, proceed as follows . Gas part = Loosen the temporarily fastened nut by half turn. Quickly tighten and connect the nut. The installing torqiue is the same as at of the gas end of the indoor unit. Liquid part Fully open the spindles of the liquid end and of the other two ends. Check that all indoor and outdoor connections are free of air leakage.
Check after installation and test operation Check after installation Electrical Safety Check 1. If the supply voltage is as required. 2. If there is any faulty or miss connection in each of the power, signal and grounding wires. 3. If the grounding wire of the air conditioner is securely grounded. Installation Safety Check 1. If the installation is secure . 2. If the water drain is smooth. 3. If the wiring and piping are correctly installed . 4.