Royal Sovereign RSH 380 Laminator Instruction Manual Provided By http://www.MyBinding.com http://www.MyBindingBlog.
13. WARRANTY Royal Sovereign International warrants the equipment sold is free from defects in material and workmanship for a period of One (1) year for Parts and Labor from the date of installation, excluding lamination rollers which are warranted for Six (6) months. This warranty is extended only to the original purchaser. This warranty is the only warranty made by Royal Sovereign International and cannot be modified or amended.
RSH-380 TABLE OF CONTENTS TOPIC 1. INTRODUCTION PAGE 1. Introduction ......................................................................................................... 3 2. Package Contents .............................................................................................. 3 3. Safety Precautions ............................................................................................... 4 Thank you for purchasing a Royal Sovereign RSH-380 Table Top Laminator.
RSH-380 3. SAFETY PRECAUTIONS 5. CONTROL PANEL Failure to comply with any of the following safety procedures could result in serious injury. Please read the instructions carefully and keep for future reference. 1. Only a licensed electrician should install wiring and outlet for the laminator. 2. Ensure the unit is plugged into a properly grounded outlet with the correct voltage. 3. Keep hands and clothing (i.e. Neckties) away from rollers.
RSH-380 6. FILM LOADING & THREADING < Film Threading > < Thermal Film Loading & Threading > Loading Film 1. Remove the upper and lower film shafts from the machine and load the films (do not tighten the core screws at this time) 2. To load the top film, insert 1" core as shown on Figure 1 (Note the direction of the film wound) Figure 1 3. Insert the shaft as shown in Figure 2. Figure 2 1. Turn the power switch on (“I” position). (The Power switch is located on the rear the unit) 4.
RSH-380 7. BEFORE LAMINATING 1. For High Quality Lamination - Refer to the "Recommended Temperature and Speed Settings" section before laminating. - The Upper and lower film tension must be same. 2. Changing Roll film. - While laminating, if the roll film needs to be replaced, press the 'RUN/STOP' button . Once the rollers stop, cut the upper and lower film, remove and replace with new rolls of film. 3. After lamination - “Hot Spots” on the rollers may occur when the machine is idle.
RSH-380 9. RECOMMENDED TEMPERATURE AND SPEED SETTINGS 1) The cross cutter is located on the rear exit table of the machine. Paper speed Temperature 4~5 100~110 C Function 80 g/m2 Paper(both side can be used) o 120g/m2 200g/m2 o (212~230 F) 25~38mic (1~1.5mil) 3~4 color paper 2) After lamination, move the cutter approximately to the center of the application at the desired point of detachment.
RSH-380 10. MAINTENANCE 12. SPECIFICATIONS 1. Do not apply any cleaning fluids to the rollers, certain fluids may cause damage. 2. Do not clean rollers with sharp objects, use adhesive remover to clean resin off the rollers. Description RSH-380 Power supply AC 100, 200, 220 240V 50/60Hz 120V 60Hz W2@6K?e?W.?g ?W.M?I46K?O.Y?g ?.Y?e?I4@0Yh 3. Use a damp cloth with only water to clean the body of the machine. Power consumption 1500W 4.Store machine in a dry clean area.
