Owner`s manual

1. Put cold roll film on upper bar.(Set the same as method of HOT film for protect
paper of lower part.)
2. Pull COLD film, and fix it so that backside protecting paper can be wound on
take-up mandrel clockwise.
(Revolve core to make protecting paper tight a little bit.)
3. Set pressure lever at the proper position following to your lamination condition.
4. After pressing the button choose and
set proper speed by using the and
button.
5. It is when ready is show
on the screen and the buzzer rings
three times (sound three times).
6. Turn on the take up device and set
the proper film tension by pressing
the button. Lower tension
would make better operation.
7. Set document on the table.should
allow at least 5mm(1/4") space on
each side for perfect laminations
8. Press
Run "button and "take up motor" at the same time.The liner and film will
be rolled at the same time.
9. When lamination is finished, press the button. For your convenience,
it would be better to set table guide in proper position. And if needed,
cut documents with cross cutter.
10. Set pressure lever at the "OPEN" mode.
11. Turn off the power switch.
1817
RSL-2702
1.Set up the protection paper. Otherwise, glue from the film will be stuck on the
face of roller and it can be seriously damaged.
2.Turn the switch "Run" and Take up motor at the same time.
3.For warm lamination, set temperature from the hot mode.
9.2. COLD LAMINATING
Reference
Cross Cutter
10. METHOD FOR USING CUTTER
1. It is on the back side of the machine.
2. After lamination, move cutter to a point
about 1/3 of the width of lamination.
3. Grasp film with one hand and press the
cutter cut downward and slide it to the
direction intending to cut with another
hand.
4. Press the cutter and slide it the other way.