Owner`s manual

1211
RSL-2702
1. Temperature available range from 0°C (32°F)
to 150°C (302°F).
2. Temperature setting of upper roller.
Press and you will see the LCD screen is
blinking 6 times. Before blinking is finished, press
or to set the temperature.
3. Set temperature of lower roller.
Press and choose the arrow button the
same way to set temperature of upper roller.
4. Each time you press the button,it
will change 1°C (2°F). If you press the button
more than 1 seconds, temperature will change
automatically until you press the button again.
5. Buzzer is ringing each time you press the button.
1. The operator can use 9 different lamination
speeds.
2. Press button then speed display
mode is blinking 6 times.
Before blinking finish, the operator can
change the speed with or .
3. Each time you press the button, buzzer will
ring.
8.2. FUNCTIONS OF BUTTONS 8.3. HOW TO USE BUTTONS
(1): Upper roller temperature controller.
(2): Lower roller temperature controller.
(3): Speed controller.
(4): Choose memorized working condition.
(5):
Increase temperature.
Increase speed.
Restore the memorized working setting.
(6): Decrease temperature.
Decrease speed.
Restore the memorized working setting.
(7): Cold and Hot mode change.
(8): Check current temperature.
(9): Saving electricity while the machine is not being operated.
(10): Reverse function.
Stay pressing reverse button to have the roller run backward.
(11): Stop working.
(12): Run the rollers.
(13): Run and stop the fans.
(1)
(2)
(7)
(10)
(3)
(4)
(5)
(9)
(12)
(11)
(8)
(6)
(13)
Set the upper/ lower hot rollers
Speed controls
Button & Display