Owner`s manual
RSL-2702
1615
1. Turn the power switch on the back side of the machine.
2. Set the pressure lever to the "Laminating mode".
3. Increase roller temperature. If you already memorized special working
condition,press button and choose right condition by using
or button.
4. When it's ready, you will see ready sign on the screen and the buzzer will ring.
5. Press the button. If rollers don't run, check the safety cover or the
table front whether it is located at correct position or not.
6. To set film tension properly, use the Handle Tension. Lower tension would make
better operation.
7. Set document on the table. You should allow at least 5mm(1/4") space on each
side for perfect laminations.
8. Press the button when your lamination is finished.
9. For your convenience, it would be better to set table guide in proper position.
10. When lamination is just finished, it is hot and easily bent. Try not to touch it until
it cools down.
11. After finishing your work, set the pressure lever to the "OPEN".
12. Turn the Power switch off.
9.1. HOT LAMINATING
9. LAMINATING STEPS
Laminating Speed at each level(mm/min)
Useful Information
1. It would be easier for you to operate the machine next time if the temperature
and the speed are set at the best condition and memorized by the using
function.
2. sign may appear on LCD window in the case continuous laminating.
If it happens, the speed needs to be lowered by one speed level and started
again after signal on the LCD window.
3. In case of wrinkling or rolling of film due to wrong position of document, is
needed to be keeping pushed in order that document could come out to the
front with buzzer sound.
4. When document is much smaller than film, you should place it in the middle of
film for preventing wrinkle.
5. Use cooling fan when you laminate continuously without break and document is
too hot.
The above laminating speed numbers are at the condition on regular voltage
with almost no film tension. There might be the possibility for difference to the
above numbers due to the change of voltage or adjustment of tension.
SPEED HOT / COLD MOLD
1300
2500
3700
4900
51100
6 1500
7 1800
8 2100
9 2500