Use and Care Manual

1. Remove all contents from the box. Gently turn the fan upside down. Loosen and remove the

2 screws (Figure A) from the bottom of the fan housing (Figure E).

2. Place the power cord (Figure D) through the slot located in the center of the rear base panel

(Figure C).

3. Align the rear base panel (Figure C) and front base panel (Figure B) and tighten using the

supplied screws.

4. Gently pull any slack out of the power cord (Figure D) and place the cord securely in the

power cord holding the bracket. Place the fan right side up and it is now ready for use.

FAN ASSEMBLY