User's Manual

2.4.4. Memory Status LED (Red)
Glowing – Memory is full.
RED LED blinking when erasing memory data.
2.4.5. Battery Status LED (Amber/Yellow)
None - Battery has adequate power supply.
Amber - Power is low. Charging immediately is required.
Yellow - Connected to power charger, charging.
LED off - Battery is fully charged.
2.5. Getting Started
2.5.1. STEP 1: Turn on Receiver and Wait for GPS
Fix
If the position has not been fixed yet, the Green LED will be still. If
the position has been fixed, the Green LED will be Glowing.
You are ready to connect to your Bluetooth-enabled mobile device
and use your GPS application.
2.5.2. STEP 2: Connect to Bluetooth-Enabled
Devices
From your Bluetooth-enabled handheld device, execute Bluetooth
application software to search MBT-1100 and then connect it to
your device. If the connection between your device and MBT-1100
is successful, the Blue LED will be Glowing.
Note: Type in pin code=0000 during configuration.
2.5.3. STEP 3: Connect to your Navigation
Software
 Load your GPS mapping or routing software, along with the
corresponding maps of the areas that you are occupying or
plan to travel to.
 Start the application. Make sure the application is set for the
COM port that your Bluetooth-enabled mobile device will use
for serial communication. Now you should be ready to use
your GPS application as directed by the user documentation
that came with the software. More configurations may be
necessary.
 Refer to the following software application user manual to set