Traxxas UDR Front Bumper Skid Plate

#81432 - Front Bumper / Skid Plate for the Traxxas Unlimited Desert Racer
What's Included: 1 - Lower Front Bumper, 1 - Bumper Support, 1 - Skid Plate, 2 - M3 x 14mm Buttonhead Screws & 2 - M3 x 25mm Buttonhead Screws

Before You Begin: Remove your stock front bumper / skid plate. Retain the following stock screws - 2 - M4 x 30 CCS (skid plate [#8537] to bulkhead [#3938]),
2 - M4 x 15CCS (skid plate [#8537] to bulkhead [#3938]) & 2 - M3 x 25mm BCS (skid plate [#8537] to tube chassis, center, front [#8431]). Retain the stock steel
support from your Traxxas skid plate [#8537].
Assembly:
Step #1
Using the 2 included M3 x 14mm Buttonhead screws,
bolt the Bumper Support to the Skid Plate. You may
install the Skid Plate to the vehicle either before,
during or after assembly.



Caution: You must transfer the stock steel support
plate from your Traxxas skid plate to the RPM
version. Running without the steel support
plate will void the RPM warranty.
Step #2
1) Slip the Front Bumper in place
on the chassis (RPM logo should
face up). Bolt the Front Bumper to
the tube chassis, center, front
[#8431], position "A" using 2 stock
M3 x 25mm BCS.
2) Slip the stock Traxxas #8535 bumper
support to the outside of position "B",
then slip the RPM Bumper Support
between the RPM Front Bumper and
stock Traxxas bumper support,
then bolt it together using the
2 included M3 x 25mm
Buttonhead screws.
Tip: To simplify maintenance, any of the three pieces of the skid plate can be removed from the vehicle without removing the other parts. This allows faster
access to the A-arm hinge pins, front bulkhead tie bar, tube chassis (center, front) and upper bumper support.
Skid Plate
Bumper Support
M3 x 14mm
Buttonhead
M3 x 25mm
Buttonhead
"A"
"B"
"A"
Front Bumper