User Manual

ManualsBrandsRPS Lighting ManualsPhoto AccessoriesWireless RF Remote Release

Wireless Shutter Release

Instructions

Features:

This device allows a Digital SLR camera to be released

from a distance up to 85 ft away, depending on conditions,

Included in the Package:

1) Transmitter with telescoping

antenna with battery

1) Receiver requires 2 “AAA”

batteries-not included

1) Hook and Loop Tape

Installing the Batteries

• Install 2 “AAA” batteries into the

back of the receiver. Be careful to

match the diagram.

• Install the 23A battery provided in the

transmitter by sliding the battery cover

to the side and then removing the

cover. The negative (-) terminal goes

against the spring contact.

Setting the DIP Switches

• Make certain that the dip switches on

the transmitter match the dip switches

on the receiver. The factory default has

all 4 switches set to OFF. Up to 16

different combinations can be set.

1 Year Limited Warranty.

Dot Line Corp. warrants that if the accompanying product proves to be

defective to the original purchaser in material or workmanship within 1

year from the original retail purchase, Dot Line Corp. will, at its option,

either repair or replace same without charge (but no cash refund will be

made).

What you must do to enforce the warranty: You must deliver, mail or

ship the product together with the original bill of sale, to:

Dot Line Corp. 9420 Eton Ave., Chatsworth, CA 91311

Phone 1-800-423-2624 Fax 818-700-9797.

Limitation of Liability and Remedies: This warranty is void if any

defects are caused by abuse, misuse, negligence or unauthorized

repairs. All liability for incidental or consequential damages is specifically

excluded. The company shall have no liability for any damages due to

lost profits, loss of use or anticipated benefits, or other incidental,

consequential, special or punitive damages arising from the use of, or

inability to use, this product, whether arising out of contract, negligence,

tort, or under any warranty, even if the company has been advised of the

possibility of such damages. The Company’s liability for damages in no

event shall exceed the amount paid for the product. The Company

neither assumes nor authorizes anyone to assume for it any other

liabilities.

Some states do not allow for the exclusion of incidental or consequential

damages, so the above exclusion may not apply to you. This warranty

gives you specific legal rights and you may have other rights which vary

from state to state.

RPS Studio Products are Marketed exclusively by:

Dot Line Corp. 9420 Eton Ave.

Chatsworth, CA 91311

818-700-9997 • Fax 818-700-9797

www.dotlinecorp.com

DIP Switches must be set the

same on both transmitter and

receiver

These Instructions are for RS-RT04/ Series Wireless Shutter Releases.

Illustrations may vary. Specifications are subject to change.

Revised March 2008.

RS-RT/04 Series

Summary of content (2 pages)

PAGE 1
Year Limited Warranty. Dot Line Corp. warrants that if the accompanying product proves to be defective to the original purchaser in material or workmanship within 1 year from the original retail purchase, Dot Line Corp. will, at its option, either repair or replace same without charge (but no cash refund will be made). What you must do to enforce the warranty: You must deliver, mail or ship the product together with the original bill of sale, to: Dot Line Corp. 9420 Eton Ave.
PAGE 2
Using your Remote Release • To trigger the camera, depress the transmitter button slightly until the LED turns green (The LED will turn green on the transmitter and the receiver) This is your prefocus light. To release the shutter, continuing pressing the transmitter button until the LED turns red. The LED will turn red on both the transmitter and the receiver. Activating the Units • Extend the antenna on the transmitter. The transmitter is activated by the button.