Operator's Manual

Page 15
Version 1.4
Copyright © 2019 RSAE Labs
08-Apr -2019
4
The LED should turn red within 5 seconds if the
charger has just been powered on. This
indicates that the battery is being “fast
charged”.
If a previous battery was just removed, it may
take up to 5 minutes for the LED to turn red. If
the battery is already charged, the LED will not
turn red but will stay green (trickle charging).
5
Allow the battery to pack charge for at least 2
hours. The battery pack can be removed when
the charger light turns green and blinks very
quickly yellow at a 2 per second rate. This is
“trickle charge” mode as described on the
bottom of the charger.
CAUTION: Failure to remove the charger from
the battery pack 8 to 12 hours after charging
has completed may result in reduced battery
life performance on the GS-6C.
6
Remove the battery back from charger.
7
Reinstall the battery pack on the main housing
and tighten the screws to “hand tight” plus ¼
turn.
3.4. Detecting Failed Batteries
Battery packs should not be used if any of the following conditions occur.
• Visible damage to battery pack