User's Manual

Programming/RF Testing
The following provides summarized steps for device
programming and testing. For complete details, refer to the
control panel installation manual.
1
With the programming keypad, browse to the ADD A NEW
DEVICE menu (Level 4).
2
Press OK/YES. The keypad displays PRESS PROGRAM
BUTTON OF DEVICE.
3
Press and release program button on siren using a paper
clip end.
The siren LED flashes.Wait for keypad display to show SIREN
(1 - 25) RECORDED.
4
Press OK/YES. The display shows RADIO RANGE TEST?
Press OK/YES again to run the test. The keypad display shows
TEST IN PROGRESS.
5
Make sure the siren is flashing indicating good
communication with the control panel. The test result must
stabilize at 8/9 minimum.
6
Press OK/YES to end the radio range test then ESC NO.
7
When finished, exit from configuration mode by a long
press on ESC NO.
INIT
Button
Opening
Button
Locking
Screw
www.videofied.com
PRODUCT INSTALL SHEET
2
OSX Outdoor Siren