User's Manual

6
W and WIP Panel www.videofied.com
1. W installation and setup
1.6 Pairing the remote keypad
• Press briefly the panel INIT button and release for the enrollment of a programming keypad.
• Insert 3 or 4 LS14500 Lithium batteries into the keypad.
• Do not mount the keypad. It will display on of the following screens:
RSI (c) 2015
videofied.com
<=========XX=========>
or
• Press on both CLR and ESC NO keys at the same time and release. The indicator LED on the keypad will blink rapidly. Wait
for the keypad to pair.
• If the keypad does not pair up with the panel and shows “XX”, it certainly means that it is stilled paired to another
system. The keypad needs to be reset. Remove the batteries and press repeatedly on the keypad tamper switch for 30
seconds to 1 minute. Then proceed to the above steps.
1.6 Indicator lights
Red LED on
Red LED blinking
(every 3 seconds)
Red LED off
Green LED on
(AC power detected)
Battery out of order
or not detected.
Low voltage on the
battery.
Normal operation
Green LED off
(AC power not detected)
Low voltage on the battery.
Panel working on
battery. Battery OK.
Panel not powered or
out of order.
INSTALLATION
MANUAL