User guide

Aries Reference Manual Section 2 – Viewing and Analysing Data
Radio Systems Information Ltd. Page 10
2.3.3 Filter by Probe
Data from all or a single probe may be selected as shown below:
Figure 8: Filter on Probe
Note that at least one probe must be selected.
2.3.4 Filter by Base Site
Data from all or a selection of base sites may be selected as shown below:
Figure 9: Filter on Base Site
Note that having all base sites unselected means that there is no filtering on base site so that all data is
displayed. If all base sites are selected then only data collected from those base sites will be displayed, so
that if data is collected unexpectedly from a base site not in the list the data will not be displayed. The
analysis time will be faster if no Base Sites are selected.