User`s manual

69
Default Configuration
In addition to the Setup configuration stored on the board, the cpuModule has a permanent default
configuration. The system will resort to using this default configuration in two situations:
• An error occurs when accessing the EEPROM which holds the Setup on the module.
• You force use of the default configuration, as explained in the following section.
The default configuration is listed below.
BIOS Default Configuration
Function Default selection
Chipset error on
Hard disk 1 not installed
Hard disk 2 not installed
Boot device Floppy
Floppy Drive 1 3.5" 1.44 MB
Floppy Drive 2 not installed
Floppy Error off
Hard disk Error off
Serial port 1 RS232 at 3F8H
Serial port 2 disabled
Keyboard AT
Keyboard Error off
Memory Error on
Memory Size 16 MB
Parallel Port LPT1 at 378H
384K remap disabled
Real Time Clock Error off
Shadow options disabled
SSD socket 1 none
SSD socket 2 none
SSD window D0000H
Video State EGA/VGA
Video Error off
Fail Safe Boot Enabled