Installation Guide

May 23,2013
Revision 00Urban Planter
User Assembly Instructions
Read these instructions and general information to properly and safely
Mold and Demold the Deep Waste Liner.
PAGE 1/1
RTS Companies Inc. | 1027 Industrial Place, St. Clements, Ontario N0B 2M0 | 1-800-663-2803
RTS Companies US, Inc. | 2900 Industrial Park Drive, Austinburg, Ohio 44010-0183 | 1-888-641-3077
Template created 5/23/2013
5602-000200-00-00,
30”x10” planter
30” x 10” URBAN PLANTER BODY --- 1pc
SINGLE LEG-BLK --- 2 pcs.
3/8”-16 HEX COUPLING NUT ZINC --- 1 pc
3/8”-16 x 4.5” HEX HEAD BOLT-ZP --- 2 pcs
3/8” FLAT WASHER ZP --- 2 pcs
5603-000200-00-00,
36”x15” planter
36” x 15” URBAN PLANTER BODY --- 1 pc.
SINGLE LEG-BLK --- 2 pcs.
3/8”-16 HEX COUPLING NUT ZINC --- 1 pc
3/8”-16 x 5.5” HEX HEAD BOLT-ZP --- 2 pcs
3/8” FLAT WASHER ZP --- 2 pcs
1. With the planter upside down, place
the rst leg on the planter. Ensure the leg
is pushed down and secured under the
mounting lip, and repeat for 2nd leg.
2. Place a washer on each bolt and slide
bolt into opening of leg as shown above.
3. Repeat step 2 with other leg.
4. Screw on the connector nut between the
2 bolts.
5. Using a 9/16” wrench and ratchet,
tighten the rst bolt as show, ensure not to
over tighten the bolts.
6. Repeat step 5 on 2nd bolt, assembly
should now be rigid and secure.
9. Completed assembly. Fill the planter
with soil and plants.
Tools required (NOT Supplied) :
One ratchet with 9/16” socket
One 9/16” wrench
CHECK CONTENTS MATCH THE ABOVE.