CLD Color Keypanel Family User Manual

Power Up

Connect a power cord to the unit and then to an AC power source. The power supply accepts 100-240 VAC, 50/60 Hz.

At power-up, if the keypanel is connected to the matrix, the alphanumeric display shows dashes in the light blue color key

. After several seconds to a minute, the intercom key assignments display with the appropriate color keys and alphas.

NOTE: If the keypanel cannot establish communications with the intercom system, all alphanumeric displays continue to

show asterisks and the Disconnected from Matrix icon appears in the display window. Check

the keypanel to matrix cable connection if this occurs. If the keypanel loses communications with the intercom,

the display window shows the Disconnected from Matrix icon immediately, but will not display for

approximately 30 seconds.

Address Setting

General Information

In ADAM, ADAM CS, and Zeus intercom systems, intercom ports are arranged in groups of eight (8). All ports in a group

share a common data port. Each keypanel is uniquely identified on the data port by its address. The method of determining the

proper address varies for each intercom system. Use the method for your intercom system, as described on the following

pages.

To see specific addressing information for ADAM with AIO-8 cards, see the ADAM installation user manual. To see specific

addressing information for ADAM CS, see the ADAM CS Installation user manual. To see specific addressing information for

the ADAM with AIO-16 cards, see the AIO-16 user manual.

NOTE: If you are connecting to an ADAM frame with AIO-16 cards or a Cronus frame, you do not need to set the

address, it is done dynamically.

TABLE 1. KP 32 CLD Addressing

Manually Addressed Automatically Addressed

You must manually address

the keypanel when using the

following:

• AIO-8 on ADAM

• AIO-16 SCSI on ADAM

• ADAM CS

• Zeus I

• Zeus II

a. To manually address the KP 32 CLD, see “Using the 3(¦) or 6(Ø), select Always On to have the keypad backlight always ON. OR

Using the 3(¦) or 6(Ø), select Always Off to have the keypad backlight never ON OR Using the 3(¦) or 6(Ø), select Activate to have

the keypad turn ON when the keypad is pressed.” on page 117.

The keypanel is automatically addressed when using the

following:

• AIO-16 MDR on ADAM

• Cronus

• RVON Products - RVON-8, RVON-1,

RVON-C, and RVON-16.

NOTE: Keypanels using RVON-I/O need to be

individually addressed. See the

RVON-I/O user manual for further

instruction.