Instruction manual

Figure C-2. Preparation of Two DV-MUX3 Units for Installation in 19" Rack
•
Fasten one short adapter bracket to theleft-hand side wall ofthe unit intended
to be on the left. Use two of the four longer screws supplied in the kit, and in-
sert flat washers.
•
Use the same procedure to fasten the second short adapter to the right-hand
wall of the unit intended to be on the right.
•
Position one of the two rails supplied in the kit on the right-hand wall of the
unit intended to be on the left, and align its holes with the holes on the wall.
•
Insert four short Philips screws and screw them through the rail into the holes
on the unit wall.
•
Use the same procedure to attach the second rail to the left-hand wall of the
unit intended to on the right. Make sure the wider rim of this rail is opposite
the short rim of the other rail, as shown in figure C-2.
Fastening the Two
Units
Refer to figure C-3 and attach the two units as follows:
•
Position the endsofthe rails attachedtothe two units sothatthe rails canslide
one into the other, and then slide the units to bring the panels in line.
•
Now insert plastic I-shaped caps between the two units, to cover the empty
spaces left at the ends of the two rails.
Figure C-3. Attachment of Two DV-MUX3 Units Before Installation in 19" Rack
The assembled units can now be fastened to the side rails of the 19" rack by means
of four screws (not included in the kit), two on each side.
APPENDIX C - RACK INSTALLATION
C-4 DV-MUX3 Installation and Operation Manual