Instruction manual

Chapter 2 InstallationChapter 2 Installation
2 2 Mounting
2 1 Unpacking
Upon receipt of the shipment remove the unit from the carton and inspect the
unit for shipping damage.
If any damage due to transit is noticed, report and file a claim with the carrier.
Record the model number, serial number, and date code for future reference when
corresponding with our service center. The serial number (S/N) and date
code (D/C) are labeled on the box and the housing of the control.
Upon receipt of the shipment remove the unit from the carton and inspect the
unit for shipping damage.
If any damage due to transit is noticed, report and file a claim with the carrier.
Record the model number, serial number, and date code for future reference when
corresponding with our service center. The serial number (S/N) and date
code (D/C) are labeled on the box and the housing of the control.
Make panel cutout to dimension shown in Figure 2.1.
Take both mounting clamps away and insert the controller into panel cutout.
Install the mounting clamps back. Gently tighten the screws in the clamp till the
controller front panels is fitted snugly in the cutout.
Take both mounting clamps away and insert the controller into panel cutout.
Install the mounting clamps back. Gently tighten the screws in the clamp till the
controller front panels is fitted snugly in the cutout.
Figure 2.1
Mounting Dimensions
Figure 2.1
Mounting Dimensions
Dangerous voltages capable of causing death are sometimes
present
in this instrument. Before installation or beginning any troubleshooting
procedures the power to all equipment must be switched off and isolated.
Units suspected of being faulty must be disconnected and removed to a
Dangerous voltages capable of causing death are sometimes
present
in this instrument. Before installation or beginning any troubleshooting
procedures the power to all equipment must be switched off and isolated.
Units suspected of being faulty must be disconnected and removed to a
To minimize the possibility of fire or shock hazards, do not expose this
instrument to rain or excessive moisture. This control is not to be used in hazardous
To minimize the possibility of fire or shock hazards, do not expose this
instrument to rain or excessive moisture. This control is not to be used in hazardous
Do not use this instrument in areas under hazardous conditions such
as excessive shock, vibration, dirt, moisture, corrosive gases or oil. The
Do not use this instrument in areas under hazardous conditions such
as excessive shock, vibration, dirt, moisture, corrosive gases or oil. The
98.0mm
Panel
10.0mm
12.5mm
SCREW
MOUNTING
CLAMP
22.2
+0.3
45
+0.5
_
0
_
0