Instruction manual

Figure 1.3 Access Hole
Overview
Figure 1.3 Access Hole
Overview
Table 1.1 DIP Switch
Configuration
Table 1.1 DIP Switch
Configuration
TC, RTD, mV
0-1V, 0-5V, 1-5V, 0-10V
0-20 mA, 4-20 mA
Input 1
Select
Input 1
Select
All parameters are Unlocked
Only SP1, SEL1 SEL5 are unlocked
Only SP1 is unlocked
All Parameters are locked
Lockout
12
34
DIP Switch
:ON :OFF
Factory Default Setting
8
*
*
The mini jumper ( programming port ) is used for off-line automatic setup and testing
procedures only. Don't attempt to make any connection to these jumpers when the
The mini jumper ( programming port ) is used for off-line automatic setup and testing
procedures only. Don't attempt to make any connection to these jumpers when the
When the unit leaves the factory, the DIP switch is set so that TC & RTD are selected forWhen the unit leaves the factory, the DIP switch is set so that TC & RTD are selected for
Lockout function is used to disable the adjustment of parameters as well as operation
SEL1- SEL5 represent those parameters which are selected by using SEL1, SEL2,...SEL5
parameters contained in Setup menu. Parameters that were selected are then allocated
SEL1- SEL5 represent those parameters which are selected by using SEL1, SEL2,...SEL5
parameters contained in Setup menu. Parameters that were selected are then allocated
Front
Panel
Rear
Terminal
Access Hole
1
ON DIP
234
The programming port connects to the
P11A hand-held programmer for automatic
programming, this also connects to an ATE
system for automatic calibration and testing.