Instruction manual

Enter the setup mode to configure each ETR-3400. Choose FULL for FUNC,

485 for COMM, RTU for PROT and select an unequal address (ADDR) for each

unit. Use the same values of BAUD, DATA, PARI and STOP for each ETR-3400,

SNA10B and ETR-Net. Also refer to and .Section 2-15 Section 4-8

Enter the setup mode to configure each ETR-3400. Choose FULL for FUNC,

485 for COMM, RTU for PROT and select an unequal address (ADDR) for each

unit. Use the same values of BAUD, DATA, PARI and STOP for each ETR-3400,

SNA10B and ETR-Net. Also refer to and .Section 2-15 Section 4-8

Taking advantage of ETR-Net software, the operator can monitor the

process on the PC screen, program the set point as well as other control

parameters such as PID values, down load the ramp and soak profile to the

controllers, execute the manual control or trigger an auto-tuning.....etc. ,

and print out a report as required. The historical data can be saved on

floppy disc, hard disc or a CD for permanent storage purpose.

Taking advantage of ETR-Net software, the operator can monitor the

process on the PC screen, program the set point as well as other control

parameters such as PID values, down load the ramp and soak profile to the

controllers, execute the manual control or trigger an auto-tuning.....etc. ,

and print out a report as required. The historical data can be saved on

floppy disc, hard disc or a CD for permanent storage purpose.

Setup Setup MenuSetup Menu

FUNC

COMM

PROT

ADDR

BAUD

DATA

PARI

STOP