Service manual

Telex Communications
164
Port Edit Box
The Port Edit Box displays the port number for the port setup currently being viewed. Typing a different port number
in this box shows the setup information for the specified port.
Port Status
Use Port Status to view connection status and data communication errors between intercom ports and the master
controller. You can also use this to upgrade the firmware in certain types of keypanels connected to intercom ports.
Port Status Screen Information
Port Status
"-- --"
Two consecutive dashes indicate that there has never been any data communication with a device at the port.
Bad Cut:
Indicates that there was communication with a data device, but communication has stopped.
OK KP 1-7
Indicates that the device connected to the port is a normally functioning keypanel. The numbers 1-7 indicates the
keypanel DIP switch settings for switches SW1-1 through SW1-3 on the keypanel rear panel as summarized in the
table below. Refer to the keypanel's installation instructions for information on DIP switch settings. In the case of a
keypanel that does not have DIP switches on its rear panel, "KP 7" will appear to indicate that the keypanel is a
normally functioning keypanel.
Number Switch Settings
SW1-1 SW1-2 SW1-3
0 Open Open Open
1 Open Closed Open
2 Closed Closed Open
3 Same as 2
4 Open Open Closed
5 Open Closed Closed
6 Closed Closed Closed
7 Same as 6