Service manual

Telex Communications
97
Operator Usage
The standard operators for input conditions (except for Current Time, Current Date, and Counter)
are:
AND both Input A and Input B must be true
OR either of Input A or Input B must be true
XOR exactly one of Input A or Input B must be true (but not both)
The following operators are only available to be used when Input A is set to "Current Date",
"Current Time", or "Counter", and in these cases Input B is then used as the value to be compared
with.
= equal to
!= not equal to
< less than
> greater than
<= less than or equal to
>= greater than or equal to
8. In the Time field, enter the time. The time is based on a 24-hour clock. For example, 4:30pm is thought of as
16:30:00.
9. From the Output Action Type drop-down list, select Load File.
A File Name drop-down list appears.
Note: All setup files are kept in the Setup file located in the TELEX folder on your C:\ drive.
10. From the File Name drop down list, select the file that will load (for example, test.adm).
Note: There is a description box near the bottom right that provides an English text description of
what the UPL statement you create will do. This allows you to play around with inputs, outputs, and
operators to see what the effect of each is.
The UPL statement is now created. Once these changes are sent to the intercom system, the setup file prepared
will automatically load at the specified time.
IMPORTANT: Activate SERVER mode. AZedit must be operating in SERVER mode for the intercom system
to be able to load the files. For more information on SERVER mode, see Connecting and Disconnecting.