User's Manual

Error! Use the Home tab to apply Titre 1 to the text that you want to appear here.
8AL90387ENAAed0a
45 /61
8 Registering the telephone
8.1 Registering the telephone on a system for the first time
For the mobile telephone to function, it must be registered on at least one Alcatel-Lucent or GAP system
(registration operation).If when first switched on the display indicates: 'System 1 Auto install ?' your
telephone has not been registered on any system.
• Auto install?
• Confirm.
Registration can begin.
A- If the system does not use an AC code.
• Launch subscription.
B- If the system uses an AC (authentication code).
• Register
• Enter the PIN Code (The default is 0000).
• Apply.
• Select a system (It is recommended that the first empty system is selected).
• Apply.
• Enter PARK code (Enter nothing if not mandatory).
• Apply.
• Enter access code (Enter nothing if not mandatory).
• Apply
• Select Power mode (You are advised not to select the 50 mW power mode unless
required. The '50mW power mode' is intended for hazardous sites such as nuclear plants
where it is requested that emissions do not exceed the maximum value.).
• Enhanced Security
• Yes / No
Call from encrypted system to un-encrypted system is accepted (yes) or rejected (no).
The registration operation can last up to 2 minutes.
• If the operation has been done correctly (subscription accepted), the telephone is ready to be used
and the radio reception quality icon is displayed.
• If the registration operation has not been successful, the station proposes launching the subscription
again.
Utilization of the telephone in GAP mode can lead to functional limitations for which no claims will be
considered under the terms of the warranty.
During registration phase, to improve security and optimize registration in a multi-system environment, the
handset enforces a minimum signal strength level to accept to register to a base station. To achieve the
conditions, it is recommended to perform registration in a place where a base station is in direct visibility
within a 20 m range. If base station is not visible the range shall be lowered.
During registration phase in a multi-system environment, all systems are scanned without priority. The
system is selected when the signal strength is above a certain level and registration matches.