Product Info

SME VoIP Handset Guide 4.8
Proprietary and Confidential
Page | 69
For Handset
SAR tests are conducted using standard operating positions accepted by the FCC with device transmitting at its
highest certified power level in all tested frequency bands, although the SAR is determined at the highest
certified power level, the actual SAR level of the device while operating can be well below the maximum value.
Before a new model device is an available for sale to the public, it must be tested and certified to the FCC that it
does not exceed the exposure limit established by the FCC, tests for each device are performed in positions and
locations as required by the FCC. For body worn operation, this model device has been tested and meets the FCC
RF exposure guidelines when used with an accessory designated for this product or when used with an accessory
that contains no metal.
For Base
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator& your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
located or operating in conjunction with any other antenna or transmitter.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
ISEDC Warning：
This device complies with ISEDC licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'ISEDC applicables aux appareils radio exempts de
licence.L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
ISEDC Specific Absorption Rate (SAR) information
For Handset
SAR tests are conducted using standard operating positions accepted by the ISEDC with device
transmitting at its highest certified power level in all tested frequency bands, although the
SAR is determined at the highest certified power level, the actual SAR level of the device while
operating can be well below the maximum value. Before a new model device is a available for
sale to the public, it must be tested and certified to the ISEDC that it does not exceed the
exposure limit established by the ISEDC, tests for each device are performed in positions and
locations as required by the ISEDC. For body worn operation, this model device has been
tested and meets the ISEDC RF exposure guidelines when used with an accessory designated for this product
or when used with an accessory that contains no metal.
For Base
This equipment complies with ISEDC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the r a diator& your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.