Installation Guide

Rubberific Splash Blocks
Rubberific Splash Blocks are light enough to move
and sturdy enough to stay in place even during the
heaviest of storms. Made from 100% recycled
rubber, these splash blocks will not crack or chip
during freeze and thaw cycles.
Installation Instructions:
If the splash block is
open at one end and
closed at the other, the
closed off edge should
be against the exterior
wall or flush with the
foundation. The water
needs to flow away from
the house rather than
toward it.
While splash blocks
typically have a built-in
downward slope, you
might need to adjust the angle of the downspout in
relation to where the splash block needs to be
installed, or the angle of both the splash block and
the downspout.
Splash blocks are installed directly beneath the
downpipes. There should be one splash block per
downspout. Splash blocks are designed to move
water away from the foundation of the house to avoid
any damage to the foundation.
The Gold Standard of
Recycled Rubber
Compliments or matches your
rubber nugget or shredded rubber
mulch
Made from environmentally-friendly
materials approved by the EPA
Made in the USA
Available in Black, Brown, Gray, and
Red
Long-lasting, durable, and
functional
After the splash block or splash blocks have been
installed, check up on them after each rainfall for five
consecutive rainfalls to see if they are working
properly or need some adjustments. Periodically
check the splash blocks for standing water,
obstructions, shifting r misalignment, and soil erosion.