Installation Guide

INSTRUCTIONS & PRODUCT INFORMATION

Installation Notes: Wood brackets are made to fit existing wood shelves measuring 5/8" to 3/4" thick x 12" deep.

Each plastic shelf is designed to hold up to 20 pounds of evenly distributed weight.

The maximum dimensions of each shelf is 25.03" wide x 12.56" deep x 1.43" high.

WARNING n You must never exceed the rated load capacity of your installed shelving system. Please consult the manufacturer

of your shelving system for the rated load capacity of your components.

Component Letter Quantity Description

A 2 Wood Shelf Attachment Bracket

(for use with your wood shelving)

B 4 Wire Shelf Attachment Bracket

(for use with your wire shelving)

C 4 Support Strap

(attached to shelves)

D 2 or 4 Plastic Shelf

(includes handles)

2-Shelf 4-Shelf

L81806114P0

PAGE 1
2-Shelf 4-Shelf INSTRUCTIONS & PRODUCT INFORMATION Component L81806114P0 Letter Quantity Description A 2 Wood Shelf Attachment Bracket (for use with your wood shelving) B 4 Wire Shelf Attachment Bracket (for use with your wire shelving) C 4 Support Strap (attached to shelves) D 2 or 4 Plastic Shelf (includes handles) Installation Notes: Wood brackets are made to fit existing wood shelves measuring 5/8" to 3/4" thick x 12" deep.
PAGE 2
1. Determine Necessary Shelf Attachment Select the required shelf attachment brackets for your existing shelving. If your existing shelf is wood, move to step 1a. If your existing shelf is wire, move to step 1b. 1a. For Existing Wood Shelving: 1b. For Existing Wire Shelving: Slide two wood brackets (A) on your existing wood shelf (slot side down) approximately 22" apart (center to center). Make sure they are pushed as far back on the shelf as possible.