Manual

ManualsBrandsRubbermaid ManualsHealth and hygiene401982

Flushing Unit for Urinals

Flushing Unit for Toilets

Battery

Compartment

Wrench

4 “C” Alkaline Batteries

Collar Wrench

Collar

Gasket

AUTOFLUSH COMPONENTS

INSTALLATION INSTRUCTIONS

AutoFlush

Unit

for Urinals & Toilets

The AutoFlush

™

sends out a continuous infrared beam that is reflected back by the presence of a person in front of the urinal or toilet.

“Object Lock”technology differentiates between someone walking past the unit or actually using the fixture.

Summary of content (4 pages)

PAGE 1
AutoFlush Unit for Urinals & Toilets ® INSTALLATION INSTRUCTIONS The AutoFlush™ sends out a continuous infrared beam that is reflected back by the presence of a person in front of the urinal or toilet. “Object Lock” technology differentiates between someone walking past the unit or actually using the fixture.
PAGE 2
1 INSTALLATION Using the supplied collar wrench, remove handle from flush valve. Note: On some flush valves with a faulty air vent, or recently flushed valve, be prepared to collect a small amount of water with a rag or sponge placed under the handle. Place collar gasket into collar nut and attach the Autoflush unit where the handle was removed.Tighten collar nut with supplied collar wrench. Note: Save handle in the event you wish to reuse for service of AutoFlush.
PAGE 3
VISUAL INDICATOR GUIDE USER-IN-VIEW L.E.D. (Green light flashes 3 times, after 5 second delay, when a user is in view. The green light flashes constantly when a user is in view during the 7 minute start up sequence). OBJECT LOCK SENSOR BATTERY L.E.D. (Yellow light flashes indicating it is time to replace batteries with 4 new “C” batteries). COURTESY MANUAL FLUSH BUTTON (Allows manual activation of flush when needed—Toilet model only).
PAGE 4
Object Lock Range of Detection Use Sensor Adjuster Tool Distance Adjustment Screw ON Distance Adjustment Near - + Far Urinal Model Only 1 2 3 ON Modes of Operation Switches Urinal Model Only ON ON ON 1 2 3 1 2 3 1 2 3 1 2 3 Normal Water Saver Sanitary Stadium Flushes before and after each use Flushes every 3 minutes with continuous use Flushes after each use Flushes after every other use Sensor Range Reset Button SWITCH NO. 3 DOES NOT AFFECT NO.'S 1 & 2.