Owner manual

ManualsBrandsRubbermaid ManualsHealth and hygiene750613

Venetian

3.5” & 5.5”

Wall Mounted

AUTOMATIC FAUCET

with Surround Sensor Technology

IMPORTANT: PLEASE READ ENTIRE INSTRUCTION

BOOKLET BEFORE YOU BEGIN INSTALLATION!

Installation & Maintenance

IMPORTANT: PLEASE READ ENTIRE INSTRUCTION

BOOKLET BEFORE YOU BEGIN INSTALLATION!

™

Summary of content (8 pages)

PAGE 1
Venetian 3.5” & 5.5” Wall Mounted AUTOMATIC FAUCET with Surround Sensor Technology Installation & Maintenance IMPORTANT: PLEASE READ ENTIRE INSTRUCTION BOOKLET BEFORE YOU BEGIN INSTALLATION! Looks Clean - Is Clean.
PAGE 2
PAGE 3
Installing Your New Faucet IMPORTANT – DO NOT USE PIPE DOPE OR TEFLON TAPE FOR ANY FAUCET OR SUPPLY CONNECTIONS! Step 1 Attach both threaded studs (F) to the back of the semi-assembled cover plate. Step 2 Attach the right angled copper pipe of the flexible connection hose (R) tube to short brass connection pipe (P) and tighten. NOTE: For Cast Iron Sinks replace the short brass connection pipe (P) with the long brass connection pipe (Q).
PAGE 4
PAGE 5
Step 9 Mount the earth ground clamp (GG) to the cold water supply pipe. Step 10 Connect the green earth ground wire (GG) to the earth ground clamp tab. Step 11 See battery compartment installation instructions below. Then connect the battery power wires together. Step 12 Test the black sensor wire (T) with your fingers. There will be a clicking sound coming from the valve control module indicating that the faucet is installed properly.
PAGE 6
PAGE 7
PAGE 8
Troubleshooting Guide Problem 1 2 Cause Install issues due to drain pipe obstructions Faucet not working (No flashing red LED located on valve control module) Faucet not working and no water flows when activated (Red LED is flashing) Improper or poor connection to power supply Low batteries Water source valves turned off If red indicator is flashing 5 times every 4 seconds, replace with new Alkaline batteries (DD). Open water source valves and check that there is water flow.