User's Manual

Ruckus Wireless ZoneFlex 2925/2942/7942 User Guide | Installation, Setup, and Placementof the AP
6
The following illustration shows the rear view of the ZF2925 AP and its major features.
LED If you see this... This is happening...
• If this LED is dark. . . . . . . . . . . .
• If green . . . . . . . . . . . . . . . . . . . .
• No power is available, or the AP is not connected to a power source.
• Power is available.
• If this LED is dark. . . . . . . . . . . .
• If steady yellow. . . . . . . . . . . . . .
• If flashing yellow. . . . . . . . . . . . .
• If steady green . . . . . . . . . . . . . .
• If flashing green . . . . . . . . . . . . .
• No link activity is detected
• A 10Mbps-capable device has been detected.
• Data is being exchanged through the WAN port at 10Mbps.
• A 100Mbps-capable device has been detected.
• Data is being exchanged through the WAN port at 100Mbps.
• If this LED is dark. . . . . . . . . . . .
• If amber . . . . . . . . . . . . . . . . . . .
• If green . . . . . . . . . . . . . . . . . . . .
• No WLAN is enabled.
• One of the WLANs is enabled, but no wireless client has associated.
• At least one wireless client has associated.
• If this LED is dark. . . . . . . . . . . .
• If red . . . . . . . . . . . . . . . . . . . . . .
• If blinking red/green alternately .
• If flashing green . . . . . . . . . . . . .
• If steady green . . . . . . . . . . . . . .
• There is no network activity; no station detected at the WLAN port
• There is a hardware problem affecting the WLAN port.
• A signal is being detected at the WLAN port, but at the lowest level.
• A moderate signal is being detected at the WLAN port.
• A strong signal is being detected at the WLAN port.
FIGURE 2-2: Rear view
[1] Power Adapter plug
Connect the power adapter to
this socket. (Input 12V 1.0A DC or
5V 2.0A DC)
[2] LAN ports
Four RJ-45 ports, supporting 10/100
Mbps connections
[3] WAN Network port
One RJ-45 port, dedicated to ISP/
broadband source connection
[4] “OTA” (Over the air) button
Not active in this model at this time
[5] Reset button
[-IF NEEDED-] Use to reset AP to
“factory default” state
1
2
3
4
5